How to install a faucet so that you can see the immediate faucet installation guide

Faucets are the most common hardware products in our lives and they control the use of tap water. However, after a long period of use, it is prone to water leakage. Many people will replace the faucet. What do you need to pay attention to when installing a faucet ? Today, we will learn to install faucets through the following contents.

Install the faucet - ready to work

Before installing the faucet, you need to be ready to use the tools used to install, check the completeness of the faucet accessories, our common accessories include a kidnapper, rubber pads, hoses and so on. Purchase a faucet and raw material tape with the same specifications from the hardware or plumbing stores. At the same time, clean the water pipes before installation, open the valve, and clean the impurities in the pipes. Then check the accessories of the taps for impurities. , to avoid causing plugging problems during installation.

Install faucet - construction phase

Before installing the faucet, the main valve of the home-installed waterway should be turned off to avoid construction trouble. Use a common spanner or pipe clamp to twist the old faucet counterclockwise. Hold the faucet with your left hand, and the right hand will wind the raw tape towards the tap's thread clockwise for a few turns, be sure to pay attention to the direction. Otherwise, it will cause water leakage. At the same time, the faucet is tightened with a wrench clockwise at the interface of the water pipe. After the construction is correct, the total valve of the water pipe is opened and the faucet can be used normally.

Install the faucet - precautions

1. If the single-hole faucet of the basin needs to be replaced, special angle valve products need to be purchased to fix the cold and hot water pipes of the outlet of the wall. If there is a difference in the distance between the angle valve and the upper water pipe, you must purchase an extension pipe. If the pipe is too long, you need to cut it short and the angle is not appropriate. You can bend it properly to adjust the required position.

2. If the wall-mounted faucet needs to be replaced, a suitable height of water pipe should be selected. The distance between the hot and cold water pipes should be at least 20 cm. If the concealed faucet is to be replaced, the faucet valve plug must be embedded in the wall, but the thickness of the wall must be taken into account. During the pre-buried process, the plastic film of the valve plug does not need to be removed to avoid damage during the pre-buried process. Should pay attention to the direction of the spool to avoid mistakes.

3. The left side of the water pipe is generally connected to hot water, and the right side of the water pipe is connected to cold water. The distance between the two pipes should be kept between 100mm and 200mm. After fixing the inlet port, remove the faucet, and then reinstall the entire wall.

Regarding the installation of faucets , Xiao Bian introduced it here for the time being. I hope to help you. If you want to learn more about tap related content, you can pay attention to this site information, more exciting content waiting for you.

Faucet hot and cold faucet faucet installation and installation faucet

LED Linear Light

Office Lighting,Architectural Lighting,Home Lighting,Modern Light,Flood Light

SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.litehomelights.com