Take the Fudun ceiling as an example. The graphic shows how the ceiling of the aluminum buckle is installed. Top golden keel: The feature is "high strength, good quality!" The installation master also said that this kind of keel was installed for the first time and it was very hard and hard. High and low ceiling: User bathroom is rather strange, the lowest place is 50cm if all in accordance with 50 to be sure to suppress the weight, so the use of high and low. Two corners of the toilet east wall, respectively, 2 sewage pipes, each with 2 elbows, an elbow 50cm from the top, one is 35cm, my bathroom would like to hang 25cm ceiling, but the sagging of the elbow is 50cm, If all use 50 centimeters, then it must be too depressing. Golden Extra Large Keel Installation officially begins: The little master made wooden pillows on the floor, and the wooden pillow was used to fix the corners. Wooden pillows have been fixed to the wall, lined up Put on the corner line The little master began to do hanging yards, and the hanging yards were used to fix the golden keel. Left side aluminum buckle, silver + white Hanging code mounted to the ceiling The keel was installed and the keel was fixed with a hanging yard. The distance between each keel was 60 and it should not exceed 1 meter. The keel on the left side of the kitchen is also installed and comes with a long view. The kitchen was all hanged, and the golden keel was beautiful The master began to spread aluminum buckle plate The entire kitchen and aisles are installed. The kitchen is the most satisfying for netizens, and the entrance door is suspended ceiling. No parquet, no embellishment, silver ribbon, plus frosted glass ceiling light The height of the bathroom was suspended and the steps between the steps and the kitchen were similar, but the masters spent a total of more than 4 hours. It can be seen that the heights on the left and right sides are not the same. The master began to install the buckle plate on the high and low sides The bathroom is too small to use a picture film and simply use a monochrome system, insisting on the path to simplicity. Carbon fiber Yuba and ceiling lamps together, very bright. Ceiling installation room glass simple glass door kitchen glass sliding door bathroom ceiling bathroom door
The auger bit adds a long deep spiral flute for effective chip removal.
Extra Long Auger Bit,Auger Drill Bit,Drill Bit With Flute,Carbon Steel Wood Working Behappy Crafts (suzhou)Co.,Ltd , https://www.haoyuebehappy.com
Two styles of auger bit are commonly used in hand braces: the Jennings or Jennings-pattern bit has a self-feeding screw tip, two spurs and two radial cutting edges. This bit has a double flute starting from the cutting edges, and extending several inches up the shank of the bit, for waste removal.
The Irwin or solid-center auger bit is similar, the only difference being that one of the cutting edges has only a "vestigal flute" supporting it, which extends only about 1â„2 in (13 mm) up the shank before ending.
The diameter of auger bits for hand braces is commonly expressed by a single number, indicating the size in 16ths of an inch. For example, #4 is 4/16 or 1/4 in (6 mm), #6 is 6/16 or 3/8 in (9 mm), #9 is 9/16 in (14 mm), and #16 is 16/16 or 1 in (25 mm). Sets commonly consist of #4-16 or #4-10 bits.