Magnetizer 9pcs hex key set,hex key set,hex keys,magnetic hex key set henan horn tools co.,ltd. , https://www.nbhorntoolsltd.com
2, small wind or electric rust. Mainly powered by electricity or compressed air, equipped with appropriate rust removal equipment, reciprocating or rotary motion to meet the rust removal requirements of various occasions. Such as angle grinder, wire brush, pneumatic needle rust remover, pneumatic rust hammer, tooth rotation rust remover, etc., are semi-mechanized equipment, tools, lightweight, mobility, can completely remove rust , The old coating, etc., can be used for roughing the coating, and the efficiency is greatly improved compared to manual rust removal, up to 1~2m2/h, but the scale can not be removed, the surface roughness is small, and the quality of the surface treatment cannot be achieved The ergonomics are lower than the jet treatment. Can be used in any location, especially in the ship repair process has been widely used.
3, blasting (sand) rust. It mainly consists of particle jet erosion to achieve surface cleanliness and appropriate roughness. The equipment includes open shot blasting (sand) rust remover, closed shot peening (sand chamber), vacuum shot peening (sand) machine. The open blasting (sand) machine is widely used and can completely remove all impurities on the metal surface, such as oxide scale, rust and old paint film. The rust removal efficiency is high 4~5m2/h, the mechanical degree is high, and the rust removal quality is high. it is good. However, due to the fact that abrasive materials are generally not recovered, they will affect other operations and clean up the site. Therefore, environmental pollution is heavier and has recently been restricted to use.
4, high-pressure water abrasive rust. The impact of the high-pressure water jet (plus the grinding action of the abrasive) and the hydrazine action destroy the adhesion of the rust and the coating to the steel plate. Its characteristics are no dust pollution, no damage to the steel plate, greatly improve the efficiency of rust removal, up to 15m2/h, good quality of rust removal. However, after the rust-removing steel sheet is easy to return to rust, a special wet rust-removing coating must be applied, which has a large influence on the coating of general performance coatings.
5, shot blasting rust. Shot blasting is the use of high-speed rotating impeller to throw abrasive on the steel surface to achieve the purpose of rust removal. It is a more advanced mechanical treatment method for rust removal of hull steel material. It not only has high production efficiency, but also has low cost and automation. High level, can achieve assembly line operation, less environmental pollution, but only operate indoors.
Removal of rust
1, dilute hydrochloric acid. Be careful not to soak the rusted stuff in it for a long time, otherwise the material inside will be reacted after the surface rust is removed. For example, in addition to the rust, it will react with iron. Chemical rust removal is mainly a kind of rust removal method that uses a chemical reaction of acid and metal oxide to remove the rusted product on the metal surface, which is commonly referred to as pickling rust removal, and can only be operated in the workshop.