Three steps for the installation of the channel translation gate

The installation of the translating brake is divided into three parts: pre-embedded, fixed translating, and function debugging.

First, the line embedded ● According to the requirements of the customer to set the chassis position, in the center of the fixed position of the chassis to the control room to choose the best route, pre-embedded or excavated cable trench.

● Put appropriate diameter conduits (PVC pipe or steel pipe) in the dug line trench to penetrate the power line and control line required by the equipment (control lines include: manual button line 3 core, RS485 communication signal line 3 core). If the distance is far away, the power line and control line must be separately piped (2 pipe distance should be above 50CM).

● Connect an 8-core machine line between two gates.

● After all lines are laid, it is best to fill the concrete after successful commissioning.

Second, the fixed translation gate ● First, the two sliding gate power, so that the wing is running to the closed state, and then align the two sliding gates, so that the wings in the same line, the distance between the wing and the wing is 3CM to 5CM

● It is necessary to test whether the infrared is aligned, and all the functions are debugged. ● Mark the ground at the center of the screw hole of the base and the edge of the chassis. Then remove the chassis and use the drill to drill holes vertically on the screw holes that mark the marks. , Size, depth to meet the requirements of the expansion screw equipment will be moved to its original position, into the expansion screw and tighten the screw;

Turn on the power:

Before power on, you should carefully check the various terminals of the main board of the brake, whether there is looseness, ensure that the mechanical part is not stuck, the operation is flexible, the equipment has been reliably grounded, there is a short circuit phenomenon, etc., and after confirming the correctness, it can be powered on.

Third, the function of debugging
● This gate is a two-way normally closed translation gate. External feed card signal, outgoing card signal.

● When there is no credit card signal, when the pedestrian enters from the entrance to the alarm. Similarly, when the card is not swiped, when the pedestrian from the entrance to the alarm.

● Pedestrian brush cartoon line: Wing open start delay, in the set pass time pedestrian pass will be closed, if the pedestrian does not pass the time the wing is closed, when someone enters in the reverse direction, the gate turns off immediately and sends an alarm, someone Or the object is in the middle anti-clip infrared, when the delay exceeds the closure, an alarm will be issued but the brake will not be turned off to avoid unnecessary injury.

PVC High Speed Roller Shutter Door

Pvc High Speed Roller Shutter Door,High Speed Automatic Pvc Door,Pvc High Speed Roll Up Door,High Speed Roll Up Door

Dongguan HengTaichang Doors Co, Ltd. , https://www.dghtcdoors.com