Light-sensitive nanomaterials

Light-sensitive nanomaterials are not new, but usually their sensing changes can only be viewed under a microscope, and this change in the light-sensitive nanomaterial produced after molecular rearrangement is visible to the naked eye.

The spiral band incorporates a nanoswitch made of a liquid crystal polymer, which irritates the material under UV light irradiation, and further controls the twisting motion through programming. It is expected to be used in software robots or microfluidic devices.

1. Product introduction


   Coal-based Column Denitrification Column Activated Carbon is cylindrical black particles. It has many characters, such as high porosity, high sulfur capacity, high desulfurization efficiency, large surface area, light weight, strong adsorption capacity, wear resistance, good water resistance, low air resistance, easy regeneration, not easy to break under high pressure etc. It is a commonly used in adsorbent.


2. Adsorption purification principle and process

   Coal-based denitrification Activated Carbon is divided into large pores (pore size greater than 50nrrt), the middle hole (pore size between 2 ~ 50nm) and micro-pore (pore size less than 2nm) three categories.

The denitrification activated carbon is by active carbon`s adsorption and catalytic activity of activated carbon. The strong catalytic effect of the active carbon for sulfur dioxide in gas, and a small amount of Oxygen in the oxidation reaction, the reaction of elemental S adsorbed the surface of activated carbon. When activated carbon desulfurization agent the adsorption reaches saturation, the desulfurization efficiency decreased obviously, it must carry on the regeneration. The regeneration of active carbon adsorption depends on the material, sulphur began to melt under atmospheric pressure is 190 degrees, 440 degrees Celsius will sublimate into gas, therefore, the general use of superheated steam temperature of about 450-500 degrees Celsius for the regeneration of activated carbon desulfurization agent. When the desulfurization agent reach high temperature, the elemental sulfur separate out activated carbon, the precipitation of sulfur into sulfur recovery pool, water cooled to form solid sulfur.

Column Denitrification Column Activated Carbon

Activated Carbon,Column Denitrification Column Activated Carbon,Air Purification Activated Carbon

Ningxia XingKai Silicon Industry Co., Ltd. , https://www.xingkaisic.com