With the rapid development of social economy, housing prices continue to climb, and how to buy a new home is too expensive? It is better to reconstruct the old house. Although the old house has a long history and the conditions cannot satisfy the living needs of the modern people, it will surely make it rejuvenate after its second renovation. Just as knowledge has to be constantly updated and technology is constantly improving, we can keep up with the glory of the times. There is a big difference between the decoration of small-sized houses and the decoration of new houses. What are the decoration techniques for small-sized old houses? The following is a detailed introduction for the decoration of small-sized and old-style houses, helping you to solve the problems associated with the decoration of a series of small-sized and old houses, such as insufficient budget, insufficient storage, insufficient lighting, home taboos, poor layout, leaking problems, and engineering problems. Let's find out together. Small apartment old room decoration - Raiders 1. Focused monitoring of concealed projects: The concealed projects such as the transformation of water circuits will directly affect the future use of life. Therefore, it is necessary to guard against obstruction during the transformation process. After years of use, the old house will be outdated, so there may be water leakage. After waterproofing is completed, a 24-hour water-repellent test must be performed to verify that the waterproof layer is intact. In general, the waterproof layer of the shower is 1.8 meters, the height of the other wall waterproof layer is 1 meter, and the waterproof height of the floor is 30 cm. If the waterway is not reformed during the renovation, it is also necessary to check if the waterproof layer is intact. During the decoration process, holes, grooving and other actions may damage the waterproof layer. Therefore, if the second-hand housing is used to remove the decoration steps of the tiles, the water-repellent test should be conducted again to ensure that the original waterproofing is not a problem. After the circuit is completed, it is necessary to check whether each socket, switch can be used normally, and whether the installation position meets the original requirements. 2, bathroom drainage can not be arbitrarily changed: some old-fashioned bathroom for the side of the drainage, and this bathroom floor height is much higher than the living room, bedroom, once the change will affect the bathroom floor structure, and even cause downstairs tenants inconvenient to use, so This type of drainage cannot be changed at will. At the same time, if you change your squat toilet to a toilet, you will need to do it again. 3, the transformation of the old brick-concrete house should be cautious: the collapse of the wall, knocked on the ground is often an inevitable project of the old house decoration, but some old brick-concrete structure in the demolition of the reform especially need to be cautious. The wall of the brick-concrete structure first plays a role in load-bearing earthquake resistance, and secondly, it is the function of enclosing partitions. If only the load-bearing wall is destroyed in order to achieve an ideal spatial pattern, the weight bearing and seismic resistance of the wall will be weakened, resulting in potential safety hazards. Therefore, in the process of demolition, renovation and refurbishment, we must take into account the housing structure and safety issues, and we should boldly innovate on this basis. Otherwise, once we “move handsâ€, it will cause irreparable damage. 4, the package must be left radiator cooling hole: Some top old houses with heating pipes, affecting the interior appearance, the easiest way is to use these pipes close to the roof as a way to wrap the ceiling. It should be noted that the circulation and flow rate of these heating pipes tend to be better than the radiators, so they will make the winter home warmer. Enough heat dissipation holes must be provided to wrap the heating pipes. This will not only allow the hot air to flow out, but also prevent cracks and deformations of the gypsum board ceilings from being “baked†by hot air for a long time. Small apartment old house decoration - Notes 1. Hidden project: The concealed project inspection is the first part of the old house decoration notice. Whether the pipes, lines, and equipment of the various facilities such as water supply, air conditioning, and ventilation in the ceiling have been subjected to closed test and electrical insulation and resistance testing, Whether the connection is firm, whether the practice meets the requirements, and whether it has been fireproofed, these are the scope of the hidden works. If you do not remove these "hidden projects" left over from the past, you will not be able to carry out inspections after the first installation. The consequences will be serious. 2. Demolition Project: If the wall is really unsatisfactory in structure, some walls need to be removed to reintegrate the space. However, in the structural reconstruction project, it must be noted that the load-bearing wall and the counterweight wall must be removed. Under the premise of security, it is necessary to change unreasonable places, remove some partitions, turn them into zero, and open the small hall with the kitchen to form a space for the kitchen. Remove the bricks containing floor tiles, kitchen tiles, etc., and then do waterproofing after plastering the walls. At the same time, a 24-hour closed water test must be performed. 3. Renovation of the Wall: How to decorate the wall in the old house is a problem that is more important, because the wall is the space that contains the entire house. The area is very large and the impact is relatively large. The renovation of the old houses' floors, walls, and roofs can be focused on the decorative materials. At the same time, professionals are required to carry out surveys on the houses. If there are obvious cracks, unevenness, falling off, and sanding, then repairs should be carried out. . Eradicate wall oil, wall paint, etc. After such a repair, it is necessary to brush a primer to cover it, so that it is mainly a solid substrate and prevents the substrate from becoming alkaline and damp. Finally, a proportioned dilution of latex paint is applied to the finish. During the construction, attention should be paid to the cleanliness of the air at the scene, and dust protection should be provided. The tool must be free of debris. 4. Door and window reconstruction: The aging of doors and windows is the most prone problem in the renovation of old houses. The degree of aging of doors and windows is divided into several cases: First, the surface of steel doors and windows is peeled off, and the main part is rusted or cracked, so as not to affect the use effect. It's best to tear down redo. The second is that if the doors and windows of the wood are peeled and deformed, the characteristics of the wood itself will change, but if the material is compact and the paint film is intact, the decorative panel can be affixed during the second construction and used. 5, hydropower reform: the old house's ground waterproof, waterways often have many unreasonable layout, the corresponding large amount of renovation projects. In many old houses, there is a phenomenon of aging wires and illegal wiring, and they need to be replaced and remodeled. In addition, it is necessary to check whether the original waterway is rusted or aged and it is unreasonable to replace it in construction. When changing lines, 2.5mm copper wire must be used for each main line. PVC insulation pipe must be worn when embedding in the wall. If it is a kitchen and a bathroom, it is necessary to first stop the floor drain and put about 5 centimeters of water for the test. Editor's summary: If a small room is full of cabinets, the relative space also reduces the living space. Instead, it's better to use the decorating money to buy some better furniture. The so-called "light decoration" concept of decoration advocates: Under a limited budget, the practical function of the home space should be the furniture decoration is the primary focus of the decoration, as the decoration of the heaven, earth and the wall is a supporting role of space decoration. The small space reduces the fixed and heavy decoration, and the space is moved out, so that people can live at ease. Small apartment dining table small apartment sun room 40 square meters small apartment decoration renderings small apartment dresser Italy small apartment
Self drilling Screw made of 410 stainless steel, high hardness (40 Rockwell C), steel process.
Drilling screw is also very strong hardness, compared to the ordinary screw up, not only to maintain the ability is good, the connection object effect is also very strong, for the performance of the screw, are generally does not need auxiliary processing, can be directly on the object directly drill a Kong Sue into objects, not just use rise very convenient, Also can greatly improve the efficiency of work. This kind of drilling screw can be said to be the first choice of workers in various fields.
So what is the use of drilling screws? Self drilling screw,hex Self drilling screw,truss Self drilling screw,flat Self drilling screw,pan Self drilling screw Shenzhen Lanejoy Technology Co.,LTD , https://www.szsmallcompressionspring.com
1 stainless steel plate, metal plate, galvanized steel plate, engineering installation.
2 metal curtain wall metal light compartment and other indoor and outdoor installation.
General Angle steel, channel steel, iron plate and other metal materials combined installation.
4, automobile, container, shipbuilding, refrigeration equipment and other assembly projects.