Salt spray test chamber installation conditions and precautions

1. Power Supply 220V Single Phase 15A

2. About 50cm away from the wall behind the machine is left to maintain space.

3. Before the machine's outside line is the 2.5mm2 power cord of the main power line, please install a no-fuse switch or doorknob switch (about 16-25A).

The drain pipe can be drained with a PVC1/2 "hard pipe, taking care that the pipe should be down.

Exhaust pipe need to use hard pipe PVC21/2 "hard pipe, extending into the outdoor discharge, pay attention to the installation of the exhaust pipe, the machine can be parallel down.

4. The installation location of the machine should be avoided by direct sunlight so as not to affect the test conditions.

5. The installation position of the machine should be as close as possible to Other electrical equipment, precision instruments or flammable materials to avoid danger.

6. This machine is made of PVC plastic, do not use force to impact, so as not to break, the temperature should not exceed the scope of the test standard, so as to avoid deformation due to overheating.