Winter temperatures are low, so home decoration must be especially concerned. The following are six tips for the winter decoration needs, I hope to help the users of the decoration. Carpenter work should be properly left seam When laying solid wood or laminate flooring, about 2 mm of expansion joints should be left at the joints. When making furniture, an interface seam of about 0.1 mm is required to avoid thermal expansion and contraction when the weather is hot, resulting in the phenomenon of drumming and dangling. Material prevents deterioration The decorative panels should be laid flat. The bottom of the panel should be covered with a large core board, and a large core board should be pressed on it. It can't stand upright. This can prevent the panel from cracking and warping. Plates, paints and other decoration materials should not be piled up next to the heating, to avoid heat deformation, resulting in the construction is difficult to normal. Plaster line to avoid loose cracks The plaster line is kept at a distance of 0.5 cm from the top surface and the wall surface to prevent the plaster line from cracking. Gypsum powder and latex can be used to reconcile the cracks at the crevices. In addition, when making plaster ceilings, the internal wooden keel must be kept dry, and it must be solid, and no loosening phenomenon can occur. Otherwise, cracks in the gypsum board ceiling can easily occur. Coating temperature above 5°C Because the ambient temperature applied by the coating should not be lower than 5°C, the construction of the decoration in winter should pay attention to closing the doors and windows to ensure that the indoor temperature is not lower than 5°C at least. In this way, on the one hand, the indoor temperature can be guaranteed. On the other hand, it is also possible to prevent outdoor sand from blowing onto unwashed furniture and wall surfaces, resulting in rough and uneven appearance. Open the doors and windows after the paint is fully dried. Fine sand cannot contain ice If there is a bricklaying work that requires cement, it is best not to construct it in the open air. It is best to use the mortar with stirring. Do not stir too much at once and avoid wasting ice. Putty is even and thick. The indoor air is dry and the water loss is fast. If the putty is too thick, it can cause hollowing, cracking, and wall inequality. Pick a warm period brush The best time to brush the walls in winter is between 10am and 4pm. The relatively high temperature during this period of time can prevent putty from freezing. In addition, due to the low outdoor temperature in the winter, tiles cannot be laid immediately after being moved into the house from outside, and should be left for at least 24 hours to allow the tile to adapt to the room temperature before being laid. Experience Talk Interior Decoration Paint Window Furniture Home Improvement Floor Tile Tile Rubber Floor Tile Wooden Acoustic Panel,Acoustic Wood Wall Panels,Soundproof Wood Panels,Sound Absorbing Wood Panels Guangzhou MQ Acoustic Materials Co., Ltd , https://www.movablepartitionwall.com