The installation of the gas stove is relatively simple. First check whether the gas is suitable. It is necessary to pay attention to the fact that the intake pipe must be fixed with a pipe clamp. The length should be suitable. If it is too long, it will increase the pressure drop caused by the resistance of the intake pipe and reduce the heat flow of the gas stove. Too short will cause pulling, and the hose will fall off easily. The specification of the hose should be matched with the joint. If the seal is not tight, it will cause air leakage. If it is too tight (such as using hot water to cover it), it will accelerate the aging of the hose. For example, if the pipeline is supplied with gas, special metal hoses and joints can be used according to the local pipe network. After the rubber pad is placed at the interface, tighten the nut. If you use a special hose connection, the joint should be tightened with a pipe clamp. In addition, it is necessary to regularly check whether the hose is cracked or peeled off. Zhejiang Keen Electric.jpg The rated gas source of the installed gas stove is consistent with the user's home gas source. Connect the hose correctly and check the connection reliability. Apply soapy liquid to the gas pipe connection and open the gas source valve. Explain the leak. Close the air supply valve and adjust the clamp (or nut) to the appropriate pressure until it is leak-free. Then put the battery into the inner casing of the battery case and confirm that the positive and negative electrodes are correct. Press it by hand until you hear a click and release your hand, and turn the clip clockwise to the end position. Put the gas stove into the embedded hole to make the gas stove and the cooktop fit smoothly. Install the fire cover and the pot bracket. If there is a positioning, it must be fixed. If there is no positioning, the fire cover and the pot bracket ensure that it is level. When the built-in dual-purpose gas stove is used as a desktop stove, it is only necessary to place four furnace feet on the bottom of the gas stove to be placed on the cooktop. Http://news.chinawj.com.cn DAYUE can customize Mold Parts according to customer needs, which is what we are very good at. We produce 1:1 according to the customer's drawings. According to the material and coating specified by the customer, and the shape of the part can be selected, such as square punch, oval punch, hexagonal punch and so on. DAYUE has 7 production lines for mold parts, they are composed of CNC Turning process, CNC Milling process, CNC grinding process, EDM process, wire END and hard material turning, so we are very good at customizing the drawings. Processing According to Drawings Custom punch,Special shape punch,Custom punch and die,Custom mold parts,Custom Dies Dayue Precision Technology (Dongguan) Co., Ltd. , https://www.dayuechn.com