Disassemble the vibrating screen bearing correctly operating method

Home>Bearing knowledge>Removal of vibrating screen bearing correct operation method
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Disassemble the vibrating screen bearing correctly operating method

Source: Bearing network time: 2014-07-26

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Improper disassembly of the vibrating screen bearing; can cause damage inside the SKF imported bearing; if the contaminant enters the SKF bearing or re-installation, the fault occurs. Therefore, the disassembly of the vibrating screen bearing must be very careful and cautious; The shaft must have proper support; otherwise, it is very capable of hurting the bearing.
The first is the disassembly of the outer periphery. When disassembling the outer ring of the interference cooperation, it is necessary to pre-set several outer ring kneading screw screws on the circumference of the outer casing; it is required to tighten the screws equally; while disassembling them. Always cover blind plugs; vibrating screen tapered roller bearings and other separate bearings; set a few cuts on the outer shoulder of the shell; use the block to open with a press; or slam the open.
Followed by the disassembly of the vibrating screen cylindrical bore bearing. The disassembly of the inner ring can be pulled out by the pressure machine. However, at this moment, the inner ring should be allowed to accept its pull force. Wuxi Danaman-Gao.
The inner ring of large vibrating screen bearing should be dismantled by hydraulic method. The oil pressure is set on the shaft to make it easy to pull. For SKF imported bearings with large width, it can be hydraulic and pull the fixture. And use; to open the work. NU type, NJ type cylindrical roller vibrating screen bearing inner ring disassembly can use induction heating method. Heating part in a short time; make the inner ring swell and then pull out.
Finally, the taper hole bearing is disassembled. When the smaller SKF bearing with the adapter sleeve is removed, the inner ring can be supported by the block fastened on the shaft; the nut is turned back several times; Hit and disassemble.

Recommend to friends comments close window

Bearing related knowledge
Several commonly used bearing types (3)
The bearing of the diesel engine hydraulic transmission system checks the faults and disposal methods of the imported bearings in the work. The reason and countermeasures of the "FAG spherical roller bearing ring" cracking How to avoid overheating of the imported bearing workpiece?


This article links to http://
Please indicate China Bearing Network http://

Previous:The bearing professor teaches you the speed and accuracy of the analysis of imported bearings and domestic bearings. Next: Does the roller bearing demand oil?

Standard function:
1.    Mushroom counter pins resistant to attack.
2.    5 rounded-head picking proof combination pins are available.
3.   Double side
4.  High quality and precision pin can reach 16807 combinations.
 
Optional function:
5.   Master Key or Key Alike are available
6.   Finish:   01-Brass polished with varnish
                  02-Bright Nickel plated

                  03-Satin Nickel Plated


Oval Cylinder Lock

Oval Cylinder Lock,Immediate Egress Cylinder Lock,Yard Key Cylinder Lock,Oval Mortise Lock Body Cylinder

Rayma(SJZ) International Trading Co., Ltd. , https://www.raymalock.com