With the advent of the 21st century, the socialist core values ​​have mentioned the word "environmental protection". Green environmental protection has always been respected by people. Of course, if you only shout slogans, you must start from the small things of real life, such as : Using a Coke bottle to make a vase is a good example. A friend who lacks a vase at home can try this method. Come and learn about it! First, the steps of the cola bottle to make the vase 1. Prepare a 500ml cola beverage bottle, cut it from the body of the bottle and cut it into two sections. 2 Vertically cut, cut to the position of the pattern to stop, cut the bottle body into a thin strip of equal width 3 first buckle the bottle down, so that the cut ears expand 4 start to compose flowers, with 4 as a group, the compilation is as shown in the figure, and the first article is good. 5 Article 2 is equally law-abiding, Article 3... 6 The method of the same method is followed in the past, and the closing is the same way. 7 vases are finished, it’s really not difficult, let’s take a look down. 8 Coke bottles to complete the vase , the perfect vase, inserted a flower, quite feel. Second, hand-made lanterns 1. Preparation materials Lead wire 3 meters (available in hardware stores, about 3 yuan for 3 yuan), 5 cm thick plastic foam board, green sticky note 0.5 m (for sale at the advertising production shop), 2 color blown papers, some candles, double-sided tape , transparent plastic, utility knife, scissors 1 preparation materials 2 wrapped chassis and flower core 3 Fix the candle on the chassis. 4 inserted petals 2. Production steps (1). Cut the lead wire into 4 lengths, 4 lengths and 8 lengths, and the short lead wire is 3/4 of the long lead wire. The length is based on your preference. The longer the lead wire, the larger the corresponding petal, the larger the lamp. (2). Cut one large and one small round plate on the plastic foam board. The large diameter is the length of the long lead wire. It is used to make the lantern base and the small flower core. (3). Cut 4 large 4 small 8 petals with blown paper, the length of the petals is 1/4 shorter than the lead. (4). Cut out a round surface slightly larger than two plastic foam boards with a sticky note. (5). Wrap the two foam boards with a sticky note. 6. Stick the lead wire in the middle of the “petal†with double-sided tape. If it is not strong enough, fix it with a transparent glue. (6). Fix the candle on the “flower core†with double-sided tape. 8. Pull out the "petal" of the lead wire and bend it a little, then insert it into the bottom plate and open the upper and lower layers. (7). Fix the "flower core" on the chassis, and the lotus lamp will be completed smoothly. 3. Small reminder (1). The wire should not be too thin, otherwise it will not function to fix the petals. (2). The chassis should be slightly larger, so that the lamp is more stable and prevented from being blown off by the wind when it is placed in the water. (3). If you want the lantern to be more beautiful, you can add a few more petals to the lamp. Coke bottles are really a good way to make vases. In the above, we also recommend the method of hand-made lanterns for everyone. You can also try them in life. Now, the steps for making vases in Coke bottles are introduced here. It’s over. To learn more about decoration, stay tuned to the home of the decoration! More related wonderful reading: What are the steps to make your own flower stand? Make the material of the flower stand yourself Brazing Carving Knives,Brazing Carving Knife,Brazing Knife,Brazing Knives Hubei Chengze Diamod Products Co., Ltd. , https://www.ryomaltools.com
