The current stage is the multi-stage of bearing damage, so it is important for us to judge the damage. Today I will tell you about the vibration and temperature of the NSK bearing to judge the bearing damage. First, the vibration of the bearing Bearing vibration is very sensitive to bearing damage. For example, peeling, indentation, rust, crack, wear, etc. are reflected in the bearing vibration measurement. Therefore, vibration can be measured by using a special bearing vibration measuring device (frequency analyzer, etc.). The size of the frequency can not be inferred from the specific circumstances of the abnormality. The measured value differs depending on the conditions of use of the bearing or the position at which the sensor is mounted. Therefore, it is necessary to analyze and compare the measured values ​​of each machine in advance to determine the judgment standard. Second, the temperature of the bearing The temperature of the bearing is generally estimated by the temperature outside the bearing. If the oil hole can directly measure the temperature of the bearing outer ring, it is more suitable. Usually, the temperature of the bearing rises slowly as the bearing starts to run, and reaches a steady state after 1-2 hours. The normal temperature of the bearing varies with the heat capacity, heat dissipation, speed and load of the machine. If the lubrication and installation parts are suitable, the bearing temperature will rise sharply and abnormal temperature will occur. At this time, it is necessary to stop the operation and take necessary precautions. The thermal sensor can be used to monitor the operating temperature of the bearing at any time, and automatically alarm or stop the occurrence of a burning shaft accident when the temperature exceeds the specified value. The high temperature often indicates that the bearing is in an abnormal condition. High temperatures are also harmful to the lubricant of the bearing. Sometimes the bearing overheating can be attributed to the lubricant of the bearing. Long-term continuous rotation of imported bearings at temperatures above 125 °C will reduce bearing life. Causes of high temperature bearings include: insufficient lubrication or excessive lubrication, lubricants. Contains impurities, excessive load, bearing damage, insufficient clearance, and high friction caused by oil seals. Therefore, it is necessary to continuously monitor the bearing temperature, whether it is measuring the bearing itself or other important parts. If the operating conditions are the same, any temperature change can indicate that a fault has occurred. The periodic measurement of the bearing temperature can be carried out by means of a thermometer, such as a skf digital thermometer, which accurately measures the bearing temperature and displays it in °C or Fahrenheit. The importance of the bearing means that when it is damaged, it will cause the equipment to stop. Therefore, it is better to install a temperature detector for this type of bearing. Under normal conditions, the bearing will naturally rise in temperature after lubrication or relubrication and last for one or two days. It can be equipped with a scrolling display that displays 300-500 words of display content. It can also be equipped with intelligent infrared probe anti-collision device, which can automatically return to work when people or foreign objects are 20-30CM, thus ensuring the safety of vehicles and pedestrians.It can automatically open and close when automatic clutch is cut off. Manually open and close when manual clutch is cut off. The control system has control panel, push button switch, and other requirements. Equipped with wireless remote control.The door body is made of high-quality stainless steel and aluminum alloy profiles, and is hinged by the parallelogram principle. The drive is driven by special motor, worm and worm gear deceleration, and has automatic clutch or manual clutch. Factory Sliding Retractable Gate,Aluminum Alloy School Sliding Gate,Automatic Electric Single Double Gate,Store Retractable Gate Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hongfadoor.com
NSK bearing vibration and temperature judgment damage degree
The current stage is the multi-stage of bearing damage, so it is important for us to judge the damage. Today I will tell you about the vibration and temperature of the NSK bearing to judge the bearing damage. First, the vibration of the bearing vibration bearing