The socket that everyone can see is the wall-mounted socket. The advantage of the wall-mounted socket is that it is in the clear place. It will not let you be injured in the power without knowing it. The use of the wall-mounted socket and the benefit of the billion-dollar are civilian equipment. Military equipment. There is a wall-mounted socket in the place where there is electricity. Since the wall-mounted socket is so popular and everyone loves it, then Xiaobian will take you to look at the wonderful contents of the wall-mounted socket. What is the difference between a wall mounted outlet and a concealed outlet? Difference: different installation methods 1, the surface mounted series is the cloth line, the bottom box is bare outside the wall, after installation is about 3cm higher than the wall surface, if the circuit has problems repairing It is more convenient, the installation speed is fast and the price is relatively affordable. The biggest disadvantage is that it is not beautiful. 2. The concealed series is the wall slotting, the duct wire, the bottom box is embedded in the wall, after the panel is installed, only one panel is highlighted on the wall surface, the effect looks more beautiful, and the furniture and other things are put up. It is also convenient and will not affect the appearance because the line is outside. 3, concealed to pay attention to is to draw the wiring diagram of the wire beforehand, in order to prevent the circuit in the future when repairing, punching holes in the wall, installing other things, causing the circuit short circuit. Be buried in the wiring, do not because the construction is not in place, resulting in unsightly lines, concealed price is more expensive. Remarks: Industrial sockets can be divided into: wall mounted sockets, concealed sockets, connectors; concealed sockets are divided into: concealed straight sockets and concealed diagonal sockets. The surface-mounted socket is the case with a rear cover box, and the rear cover box is directly connected with the cable hole of the cable or the nylon tube, and is generally distributed at the factory for use on the wall; Concealed socket: Relatively mounted is no rear cover box, generally used for mechanical equipment or engineering power supply, the installation panel, the general hardware panel is first opened the installation slot, the socket power supply from the panel inside the line --- dark line, see Not enough, of course, it is called concealed installation (darkly installed). Straight and oblique difference: Straight socket jack is opposite to the panel, perpendicular to the panel. If the installation position is close to the operator's body, it is easier to operate. If the installation position is higher than the operator holding the plug socket, use the oblique The socket is easier, and the angle of the angled socket is 20 degrees from the panel. The above content is the introduction of the relevant contents of the wall-mounted socket. I hope that readers will be able to see it and use it in real life. Well, today's introduction to the wall-mounted socket is here. Thanks to the readers for reading this article and for the support and love of Xiaobian. If you want to get more home decoration information, please continue to pay attention to the decoration home. network.
Power fitting Db Type Adjusting Plate is one Steel Plate with many holes but different hole distance;
If you have any questions, please contact with us directly. Adjustment Plate,Pt Type Adjusting Plate,Db Type Adjusting Plate,Galvanized Steel Adjusting Plate Shandong Vantage International Trade Co., Ltd. , https://www.steelplate.be
it is applicable to insulation fitting for adjusting the length of twin-connecting or parallel-connecting insulator string through series connection with insulator string. The adjusting plate is also serially connected with the section of bundled conductor between connecting fitting & tension clamp subjected to tension insulator string as the looseness adjustment of two pieces of bundled conductor.
Link Fitting Pt Type Adjusting Plate is exclusively used for twin-connected rotation angle insulator string & tension insulator string. On usage, the adjustment of length to adjusting plate depends upon the rotation angle of angle tower to calculate the distance length between the two suspending points subjected to insulator string.
Our company is solemnly committed to the majority of customers: reasonable price, short production cycle, considerate service. We look forward to cooperating with you.