Common bearing outer ring fixing method

Home>Bearing knowledge>Fixed method for common bearing outer ring
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Common bearing outer ring fixing method

Source: China Bearing Network Time: 2014-10-07

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1. The retaining ring is fixed to the outer ring of the radial bearing with a retaining groove. This fixing method can be used. The layout is simple and the axial dimension is small. Large axial load cannot be accepted.
2. The circlip retaining ring has a simple layout, convenient assembly and disassembly, and small axial dimension. An adjustment ring is added between the bearing end face and the retaining ring; the axial orientation of the bearing can also be adjusted; compensation processing and installation error are applicable. To the occasion where the load is not large.
3. The end cap is fixed for the fixing of the centripetal and centripetal thrust bearings at the shaft end. The end cap can be made in various forms. When the end cap is a through hole; it can also be equipped with various sealing devices. Suitable for high speed; axial load Larger occasions.
4. The threaded ring is fixed for high speed and large axial load. The threaded ring can also adjust the bearing clearance of the radial thrust bearing face to face. However, the threaded ring should have anti-loose method.
5. The conditioning screw and the adjustment cover are fixed similarly to the end cover. This type of equipment facilitates the conditioning of the bearing clearance outside the box. The conditioning screw should have a loosening method.
Recommend to friends comments close window

Bearing related knowledge
Analysis of several commonly used bearing types for the disassembly of TIMKEN bearings (5)
Bearing housing selection
Analysis of the precautions when using KOYO bearings: Smooth handling of oil film NSK bearing oil


This article links to http://
Please indicate the bearing network http://

Previous: Bearing Knowledge Encyclopedia (2)
Next: Common bearing wear problems and common cleaning methods

The microstructures inside duplex stainless steels are approximately 50 per cent austenite and 50 per cent ferrite, and consequently duplex steel tube share the physical properties of both ferritic and austenitic grades. Duplex stainless steel has excellent chloride and stress corrosion resistant porperties. it is suitable to apply in oil refining, petroleum and gas industry on the ground and sea situation. Duplex stainless steel has roughly twice the yield strength of their counterpart austenitic grades, so it could be produced as thinner gauge tubing and high precision tubes.

Max Stainless Steel (CNMAX)manufactures duplex stainless steel tubes in the following grades:

Alloy

UNS

WNR

Duplex

S31803

1.4462

Super Duplex

S32750

1.4410

Super Duplex

S32760

1.4501

Duplex Steel Tube

Duplex Steel Tube,Duplex Steel Pipe,Duplex Stainless Steel Tube,Duplex Stainless Steel Welded Tube

Zhejiang Max Stainless Steel Co.,Ltd , https://www.cnstainlesstube.com